Roadmaster Tail Light Wiring Kit Installation - 2007 Saturn Vue- Video
Today on our 2007 Saturn Vue, we're gonna be showing you how to install the Roadmaster Tail Light Wiring Kit for Towed Vehicles. This is the LED bulb and socket kit. The part number is: RM-152-LED. Now, our wiring installation process is gonna begin just before we put the fascia back on the car. This is gonna give us an ideal time to get in here without the fascia being in the way and restricting our access. So we're gonna go back behind the engine compartment now and route our wire up so it'll come out in this area down around where our bracket's gonna be located. more
7/24/2017 2:12:50 PM
Roadmaster Diode 7 to 6 Wire Coil Kit Installation - 2008 Saturn Vue- Video
Today on our 2008 Saturn Vue we're going to be showing you how to install the Roadmaster Diode Towed Vehicle Wiring Kit with the seven wire to six wire flexo coil. Part number is RM-15267. Now, for the towed vehicle wiring kit our installation of our four pole wire, it's going to start well before you get the fascia put back on the car. We do this during the base plate process, and it's going to allow us to route our wire in behind that fascia where we wouldn't normally be able to reach so we can get it nice and secure, make sure we don't have any loose edges or anything like that, or any wires hanging any places we don't want. Get that to come down through. Basically, just going to go by the end of the battery here, and then we can route this across and down to our plug area here. Now, I've already attached the bracket just to give us an idea of where that's going to sit. more
3/1/2017 1:58:17 PM
TrailerMate Tail Light Wiring Kit for Towed Vehicles Installation - 2007 Saturn Vue- Video
Today on our 2007 Saturn Vue well be installing the Trailermate custom tail light wiring kit for towed vehicles, part number TM780035. Our first step will be opening up the rear cargo door. Then well remove the two fasteners that secure the tail light assembly to the vehicle. Now as we remove the tail light assembly be careful not to break the alignment tabs underneath. Next well remove the manufacturers wiring from the tail light assembly. Pull back on the locking tab and remove the connector. more
11/15/2012 9:47:51 AM
Filter Videos
Filter Videos
